Adsorption properties of surface chemically pure sodium perfluoro-n-alkanoates at the air/water interface: counterion effects within homologous series of 1:1 ionic surfactants.

Abstract

The unusual behavior of saturation adsorption calculated from experimental equilibrium surface tension (σ(e)) versus logarithm of concentration (c) isotherms within the homologous series of aqueous sodium perfluoro-n-alkanoate solutions represents a particular problem in the adsorption of homologous ionic 1:1 amphiphiles at fluid interfaces. Special precautions were taken to guarantee surface-chemical purity for all solutions, avoiding falsifying effects by surface-active trace impurities. Surprisingly, all homologues' adsorption isotherms reveal ideal surface behavior. The minimal surface area demand per molecule adsorbed for shorter-chain homologues slightly decreases with increasing chain lengths but then goes up steeply after having passed a minimum. A similar feature has been observed with the chemically quite different homologous series of the hydrocarbon surfactants of sodium-n-alkylsulfates. Comparing the corresponding 3D saturation concentrations in the boundary layer and in the bulk, it becomes evident that at high bulk concentrations when boundary layer and bulk concentrations are of the same order of magnitude the adsorption behavior may be treated as that of a pseudononionic surfactant. However, under conditions of the homologues' strongest surface activity, adsorption seems to become increasingly governed by electrostatic repulsion, resulting in increasingly greater cross-sectional areas. Deviation from pseudononionic behavior sets in when the Debye length becomes distinctly greater than the adsorbent's diameter at saturation. Formerly available theories on ionic amphiphiles' adsorption deal either with electrical conditions of surfactant ions and counterions in the adsorption boundary layer or alternatively with pseudononionic behavior neglecting the former theories completely. Warszynski et al.'s novel theoretical model of the "surface quasi-two-dimensional electrolyte" seems to be capable of describing the adsorption of ionic amphiphiles at fluid interfaces in general. We conclude that the conditions of the two alternative approaches may be met within homologous series of ionic amphiphiles as limiting cases only.