Adsorption of steroid hormone micropollutant by polyethersulfone ultrafiltration membranes with varying morphology

Abstract

The effective removal of micropollutants necessitates the use of dense membranes, such as thin-film composite (TFC) reverse osmosis (RO) and nanofiltration (NF) membranes. TFCs have a polyamide active layer interfacially polymerized on a support layer that is typically made of polysulfone (PSu) or polyethersulfone (PES). Retention by NF and RO is often incomplete because micropollutants are adsorbed to the polymer material and subsequently permeate via a combination of convection and diffusion, which evidences a breakthrough curve. When describing breakthrough phenomena, the role of the support membrane is commonly neglected, even though the adsorption in this layer can be significant. This work investigated the adsorption of steroid hormone micropollutants (17β-estradiol, E2) by fabricated and commercial PES ultrafiltration membranes with varying morphology.By increasing the coagulation bath temperature between 10 and 70 °C, the pure water permeability increased from 13 to 3800 L/m2·h−1·bar−1, and consequently, the average pore size rose from 12 to 191 nm. The fabricated membranes with smaller pore sizes showed higher E2 removal via adsorption which can be attributed to the higher internal surface area. The adsorbed mass of fabricated PES membranes (using dimethylformamide (coded as PDG) and N-methyl-2-pyrrolidone (coded as PNG) and PES (Istanbul Technical University (ITU), with non-woven supports) varies from 0.30 to 0.60, 0.27–0.60 and 1–1.2 ng·cm−2, respectively. These values are lower than the adsorbed masses with commercial Biomax (Millipore Inc.) membranes (0.5–2.0 ng·cm−2). Ultrafiltration membranes used as support for composite membranes, nanofiltration or as filters in sample preparation benefit from lower micropollutant adsorption.