Abstract
Adsorption of low-molecular adsorbates (nonpolar hexane, nitrogen, weakly polar acetonitrile, and polar diethylamine, triethylamine, and water) onto individual (silica, alumina, titania), binary (silica/alumina (SA), silica/titania (ST)), and ternary (alumina/silica/titania, AST) fumed oxides was studied to analyse the effects of morphology and surface composition of the materials. Certain aspects of the interfacial phenomena dependent on the structural characteristics of oxides were analysed using calorimetry, 1H NMR, and Raman spectroscopies, XRD, and ab initio quantum-chemical calculations. The specific surface area S BET,X-to- S BET,N 2 ratio (X is an organic adsorbate) changes from 0.68 for hexane adsorbed onto amorphous SA8 (degassed at 200 °C) to 1.85 for acetonitrile adsorbed onto crystalline alumina (degassed at 900 °C). These changes are relatively large because of variations in orientation, lateral interactions, and adsorption compressing of molecules adsorbed onto oxide surfaces. Larger S BET,X/ S BET,N 2 values are observed for mixed oxides with higher crystallinity of titania or/and alumina phases in larger primary nanoparticles with greater surface roughness and hydrophilicity. Polar adsorbates can change the structure of aggregates of oxide nanoparticles that can, in turn, affect the results of adsorption measurements.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
