Adsorption of methylene blue from an aqueous dyeing solution by use of santa barbara amorphous-15 nanostructure: Kinetic and isotherm studies

Abstract

Santa Barbara Amorphous-15(SBA-15) nanoparticles were utilized as the inexpensive and effective adsorbents to remove methylene blue dye from the aqueous solution.SBA-15 was created by Zhao et al method. Infrared spectroscopy, X-ray diffraction and scanning electron microscopy (SEM) were used for the evaluated physical properties of SBA-15. The results of diffraction X-ray indicated that was the crystalline structure for it. Also IR spectroscopy indicated was a silica the whole structure of the groups and SEM image verify the structure of relatively identical particles size of SBA-15. Factors affecting adsorption including the amounts of adsorbent, pH and contact time were investigated by a SBA-15 nanomaterial design. The extent of dye removal enhanced with increasing initial dye concentration and pH from 4 to 10. The higher percentage adsorption were obtained under optimum conditions of variables (sorbent dose of 200 mg/liter, initial MB concentration 10 mg/liter, initial pH of 10 and temperature of 25oC). Maximum adsorption happened after the 2 hour and the kinetic processes of the dyes adsorption were described by applying the pseudo-first-order and the pseudo-second-order and the relatively High correlation with the kinetic Ellovich models. It was found that the pseudo-second-order models kinetic equation described the data of dye adsorption with a good correlation (R2>0.999) which indicated chemisorption mechanism. Freundlich and Langmuir adsorption models were investigated in conditions of variables (adsorbent dose 0.01 gr/liter, MB concentration 10, 20, 30 mg/liter, pH of 4, 7, 10, contact time 90 min and temperature of 27oC). The adsorption data were represented by Langmuir isotherm model. These values are higher than the adsorption capacities of some other adsorbents that have recently been published in the literature.