Adsorption of crystal violet dye onto a mesoporous ZSM-5 zeolite synthetized using chitin as template

Abstract

HypothesisZSM-5 zeolite is an efficient adsorbent for several compounds. However, is a microporous material, and consequently, is little efficient for large dye molecules. In order to make ZSM-5 zeolite a mesoporous material with ability to adsorb dyes, the use of chitin (low-cost biopolymer) as template in the synthesis route can be an alternative. ExperimentsZSM-5 zeolites were synthetized using a nucleating gel as structure-directing agent for the material formation, followed by the chitin insertion (or not), homogenization and hydrothermal treatment. The obtained zeolites (ZSM-5 and chitin/ZSM-5) from these different methods were characterized. The potential of ZSM-5 and chitin/ZSM-5 zeolites to adsorb crystal violet dye (CV) was evaluated in batch mode, considering the effects of adsorbent dosage and pH. Equilibrium, thermodynamic and kinetic studies were also performed. FindingsThe use of chitin in the synthesis route provided the following improvements on the ZSM-5 structure: (i) the mesopores volume increased from 0.027 (ZSM-5) to 0.142cm3g−1 (chitin/ZSM-5); (ii) the pore diameter increased from 1.97 (ZSM-5) to 22.49nm (chitin/ZSM-5); (iii) the porosity was increased and the crystallinity was decreased. For both, ZSM-5 and chitin/ZSM-5, the CV adsorption was favored with adsorbent dosage of 2.0gL−1 and pH of 7.5. The pseudo-second order model was suitable to represent the adsorption kinetics and, the Langmuir model was adequate to represent the equilibrium. The maximum adsorption capacity increased from 141.8 (ZSM-5) to 1217.3mgg−1 (chitin/ZSM-5). The adsorption was spontaneous, favorable and endothermic.