Abstract

Adsorption of a low linear charge density cationic polyacrylamide (CPAM) onto monodisperse silica particles has been studied over a wide range of KCl concentration (10−3–1M) and pH (4–9). In parallel the surface charge density of silica particles with and without adsorbed polyelectrolyte has been determined. The adsorbed amount (Γ) as a function of electrolyte concentration (cs) exhibits a maximum atcs≈ 0.1M.As pH increases from 4 to 6, Γ increases and then either reaches a plateau (cs≤ 0.1M) or decreases (cs> 0.1M). These features can be rationalized in terms of the interplay between the different factors that govern polyelectrolyte adsorption. The effect of polyelectrolyte adsorption on the surface charge density of silica is largest at lowcs. It decreases with increase of the salt content and vanishes atcs> 0.1M.This suggests that at electrolyte concentrations lower than 0.1M,the polyelectrolyte plays a dominant in surface charge regulation. The ratio of the adsorbed polyelectrolyte charge to total surface charge is close to unity at high pH. It increases drastically with decreasing pH and increasing salt. A large overcompensation of the substrate charge by polyelectrolyte at these conditions is established in the present work.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.