Abstract
Abstract The removal behavior of fluoride ions was examined in aqueous sodium fluoride solutions using a titanium hydroxide-derived adsorbent. The adsorbent was prepared from titanium oxysulfate (TiOSO4·xH2O) solution, and was characterized by X-ray diffraction, scanning electron microscopy, thermogravimetry–differential thermal analysis, Fourier transform infrared spectrum and specific surface area. Batchwise adsorption test of prepared adsorbent was carried out in aqueous sodium fluoride solutions and real wastewater containing fluoride ion. The absorbent was the amorphous material, which had different morphology to the raw material, titanium oxysulfate, and the specific surface area of the adsorbent (96.8 m2/g) was 200 times higher than that of raw material (0.5 m2/g). Adsorption of fluoride on the adsorbent was saturated within 30 min in the solution with 200 mg/L of fluoride ions, together with increasing pH of the solution, due to ion exchange between fluoride ions in the solution and hydroxide ions in the adsorbent. Fluoride ions were adsorbed even in at a low fluoride concentration of 5 mg/L; and were selectively adsorbed in the solution containing a high concentration of chloride, nitrate and sulfate ions. The adsorbent can remove fluoride below permitted level (
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
