Adopting co-metabolism strategy for optimized biotreatment of ortho-hydroxytoluene and bioelectricity generation in microbial fuel cell: Transformation products and pathways

Abstract

This study investigated the effects of carbon source availability and concentrations, external loads (Rload), and cathode conditions on the overall removal rate of ortho-hydroxytoluene and bioelectricity generation characteristics in anti-gravity flow microbial fuel cell (AGF-MFC) through co-metabolism approach. Sodium acetate outperformed sucrose, glucose and carbamide, and the optimum influent acetate concentration (1000 mg L−1) significantly enhanced the o-hydroxytoluene degradation by 13.41 % (98.71 %), output voltage by 15.14 % (609.25 mV) and power generation by 30.96 % (159.44 mW m−2). The results demonstrated that there were prominent differences in MFC performances under different Rload (p < 0.05). Different external load conditions resulted in varying electron transfer reactions, and thus affecting the removal efficiency and power responses of MFC system. A complete removal of o-hydroxytoluene and highest power density of 173.10 mW m−2, with a Chemical Oxygen Demand (COD) removal of 93.56 % were obtained with the Rload of 230 Ω, where the Rload approaches the cell design point. Hysteresis phenomenon was detected in the dynamic polarization during Rload variations. Moreover, it was observed that the removal efficiency of o-hydroxytoluene was significantly enhanced with aeration rate of 50 mL min−1, and dissolved oxygen concentration of 5.4 mg L−1. Conversely, higher aeration rate (400 mL min−1) had caused a decline of 26 % in power generation, ascribed to the limited active surface area for oxygen reduction reaction. Additionally, the degradation pathway of o-hydroxytoluene was proposed based on the identified intermediates.