Abstract
Bioaerosols produced by municipal wastewater treatment plants (MWTP) can spread in air, thereby polluting the atmosphere and causing safety hazards to workers and surrounding residents. In this study, the biological reaction tanks (BRTs) of six MWTPs undergoing typical processes in North China, Yangtze River Delta, and the Greater Bay Area were selected to set up sampling points and investigate the production characteristics of bioaerosols. The Atmospheric Dispersion Modelling System method was used to simulate the diffusion of bioaerosols in the MWTPs. The concentrations of bacteria and, specifically, intestinal bacteria in the bioaerosols ranged from 389 CFU/m3 to 1,536 CFU/m3 and 30 CFU/m3 to 152 CFU/m3, respectively, and the proportion of the intestinal bacteria was 8.85%. The concentration of soluble chemicals (SCs) in the bioaerosols was 18.36 μg/m3–82.19 μg/m3, and the main SCs found were Mg2+, Ca2+, and SO42−. The proportion of intestinal bacteria (75.79%) produced via surface aeration by a BRT attached to large-sized bioaerosol particles was higher than that of a BRT undergoing the bottom aeration process (37.28%). The main microorganisms found in the bioaerosols included Moraxellaceae, Escherichia–Shigella, Psychrobacter, and Cyanobacteria. The generation of bioaerosols exhibited regional characteristics. The wastewater treatment scale, wastewater quality, and aeration mode were the main factors influencing bioaerosol production. Model simulation showed that, after 1 h, the diffusion distance of bioaerosol was 292 m–515 m, and the affected area was 42,895 m2–91,708 m2. The diffusion distance and range of the bioaerosols were significantly correlated with the concentration at the bioaerosol source and the aeration mode adopted by the BRTs. Wind speed and direction were two environmental factors that affected the diffusion of bioaerosols. With an increase in the diffusion distance, the concentration of microorganisms, intestinal bacteria, ions, and fine particles in the bioaerosols decreased significantly, resulting in a corresponding reduction in the exposure risk. This study provides new insights to help predict bioaerosol risks at MWTPs and identify safe areas around MWTPs. The study also provides a basis for selecting safe MWTP sites and reducing bioaerosol pollution risks.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.