Abstract
The cold spray process and laser-induced projectile impact test (LIPIT) are used to deposit Ti powder particles on sintered polycrystalline Al2O3. Whereas LIPIT allows real-time observations of single particle impact and measurement of particle impact velocity, cold spray rapidly and simultaneously deposits particles with a wide range of deposition velocities and sizes. By use of these two techniques, the effect of particle velocity and substrate morphology on adhesion strength of single splats is investigated. The critical velocity for deposition is identified to be approximately 580 m/s for the Ti/Al2O3 system when using LIPIT and particles of 10 μm. Above the critical velocity, flattening ratio (FR) is also evaluated and observed to be linearly dependent on the particle impact velocity. Splat adhesion testing is performed on LIPIT-deposited as well as on cold spray-deposited powder particles to measure adhesion strength. This analysis shows that adhesion strength is highly affected by local substrate surface morphology, where particles bond more weakly to relatively smooth portions of the substrate. Therefore, mechanical bonding plays a significant role in adhesion. Also, adhesion strength decreases with an increase in FR and therefore velocity. This decrease can be associated with fracture of the ceramic substrate and rebound forces.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
