Adhesion of NCF to oxidized Si wafers after oxygen plasma treatment

Abstract

The effect of oxygen plasma treatment on the adhesion between nonconductive film (NCF) and oxidized Si was investigated. Oxidized Si wafers were treated with oxygen plasma for 5min and then rinsed in de-ionized water (DIW). The water contact angle was measured by means of the sessile drop technique and the surface roughness was measured by means of atomic force microscopy. The adhesion of the NCF to the oxidized Si wafer was evaluated by means of a single-lap shear test after bonding at 150°C for 5 s. Oxygen plasma treatment decreased the water contact angle. The roughness of the oxidized Si wafer decreased when oxygen plasma treatment was applied alone, but was increased when both oxygen plasma treatment and DIW rinse were applied. Similarly, the shear strength decreased when oxygen plasma treatment was applied alone, but the adhesion of NCF increased when both oxygen plasma treatment and DIW rinse were applied. The increased surface roughness of the oxidized Si wafer played an important role in increasing the adhesion between the NCF and the oxidized Si wafer. The shear strength further increased after post-heat treatment at 170°C for 1 hr or at 280°C for 15 s. Low shear strength observed before post-heat treatment was ascribed to incomplete NCF curing. Differences observed in the adhesion strength between two types of NCF were attributed to differences in their curing degrees and their degrees of surface coverage of the oxidized Si substrates.