Year-end Sale % OFF 
Abstract
In order to continue our work on surfactant effects on the adhesion properties of latex films, we investigated a new system based on an acrylic copolymer, synthesized in the presence of a hydrophilic polyester. The surfactants were either sodium dodecyl sulfate (SDS) or an ethoxylated nonyl phenol containing 30 ethoxy groups (NP30). As substrates, either glass plates or poly(ethylene terephthalate) (PET) films were used. This article describes the analysis of the loci of failure after peeling of the films. The analytical techniques used were X-ray photoelectron spectroscopy (XPS) (or ESCA), static secondary ion mass spectrometry (SSIMS), and contact angle measurements. It was shown that the loci of failure were independent of the peel rate and of the nature of the substrate. The failure occurs in a thick surfactant layer for SDS, and in a thin one for NP30. The thickness of the layer increases with the concentration of surfactant in the latex film. The surfactant is located near the surface of the substrate, on top of a layer of hydrophilic polyester. The consequences of the structure of the film-substrate interface on the adhesion properties is presented in Part III in this series.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
