Adhesion of blood platelets under flow to wettability gradient polyethylene surfaces made in a shielded gas plasma

Abstract

Adhesion and activation of platelets are important steps in the thrombosis of blood after contact with a biomaterial surface and are governed, in part, by the wettability of the surface. Since most implanted devices are in contact with blood under flow conditions, it is important to study the effect of wettability of device surfaces on the behavior of platelets also under flow. To this end, wettability gradient polyethylene surfaces were prepared through glow discharge with partial shielding over a length of 5 cm, with advancing water contact angles varying from 95 to 45 degrees and a contact angle hysteresis of 30 degrees. The role of blood flow on the adhesion of platelets was examined by incubating these gradient surfaces in anticoagulated, whole human blood under static conditions or in blood under a flow of 10 or 40 ml/min through a 3 mm diameter circuit or for 5 or 15 min with either the hydrophobic or hydrophilic end upstream. Generally, more platelets adhered on the hydrophilic end of the wettability gradient than on the hydrophobic end, although the increment along the wettability gradient was dependent on both the flow conditions and direction. More platelets adhered under a flow of 10 ml/min than under static conditions, due to higher mass transport. Especially when the hydrophilic end was upstream, there was a more pronounced adhesion. This can be explained in terms of immediate platelet activation by shear stress imposed at the upstream end. During flow of 40 ml/min, platelet adhesion on an upstream hydrophilic end was less than on a downstream hydrophilic end. We conclude that platelets detach from the hydrophilic end at high shear stress due to the spherical form of adhered platelets. Platelets on the hydrophobic end could withstand detachment by strong, flat shaped platelet-material contact.