Abstract
This paper deals with the additive manufacturing by 3D printing of the Hose Pipe DN 50 landmark which is part of the Gas Reduction R2-Hose DN 2 in subassembly. This sub-assembly is a component part of the washing head of the light water well drilling installations FA 100, FA 125, FH 150 and FG 40. The generic name of the washing head will be FA 100. We use 3D printing technology because, on the one hand, it is technically possible to make the part and on the other hand, for economic reasons. It is approximately ten times cheaper to make the part through 3D printing than through conventional technologies.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: The Annals of “Dunarea de Jos” University of Galati. Fascicle IX, Metallurgy and Materials Science
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
