Abstract
The amalgamation of digital light processing (DLP) technology and pressureless sintering has emerged as a promising method for producing delicate, complex, and custom-made yttria-stabilized zirconia (YSZ) components. The procedure consists of fabrication of green part using DLP, debinding to remove the binders and sintering to densify the parts. Explorations in the parameter selection in each step are still far from maturity for producing defect-free densified parts. This study addresses the effect of DLP print parameters on the density of green parts and surface irregularities. DLP printing parameters, such as layer thickness, orientation, and light intensity, were selected, and a central composite design methodology was adopted for the design of experiments to investigate the impact of individual parameter as well as their interactions. The density of the green part decreased with an increase in layer thickness from 10 μm to 70 μm, whereas an increase in density was observed when the part orientation changed from 0 ° to 90°, and the intensity changed from 10 to 50 mW/cm2. The variations in layer thickness and part orientation substantially impact the surface roughness, but variations in intensity have comparatively less influence on the surface roughness. The in-layer and inter-layer voids of the samples fabricated with varying parameters were analyzed using scanning electron microscopy. The minimum surface roughness and maximum green part density responses were obtained using regression equations and a multi-objective optimization strategy. Subsequently, the samples were debinded and sintered to produce high-density zirconia components. To establish the importance of parameter optimization, a comparison of the specimen density and surface irregularity in the green and sintered states was performed for specimens fabricated with optimized parameters and a randomly chosen set of parameters. The novel study provides the parametric relation to fabricate as desired green and sintered density parts along with tuned surface roughness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.