Abstract
Microstructural development in directed-energy additive manufacturing of metal components is a complex process that produces parts with materials whose microstructure and properties are influenced by multiple heating and cooling cycles. Much work has been undertaken to correlate microstructural development with processing conditions, such as laser power and processing speed. Here, the microstructure and indentation hardness of a Ti-6Al-4V component processed with a pulsing laser beam and a continuous wave (CW) laser beam are investigated. It is found that the pulsed-beam build showed no statistically significant variation in lath width or indentation hardness with build height while the build deposited with the CW beam showed a statistically significant decrease in hardness and an increase in lath width near the middle of the build. The reduction in variability with beam pulsing is attributed to rapid cooling rates within the melt pool, a greater degree of melt pool stirring, and reduced aging during part build-up.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.