Adaptive power sharing scheme for parallel‐connected hybrid inverters in microgrid

Abstract

This paper presents an adaptive power sharing control method of parallel-connected hybrid inverters in microgrid. Normally the AC microgrid is composed of hybrid inverters, other power generation equipment and some loads in parallel. Droop control or virtual synchronous generator is usually adopted to control parallel inverters, so the output power ratio between each inverter is fixed by droop parameters. The input of hybrid inverter is PV panel and battery, so the power output ability of each hybrid inverter is different because of the different PV panel capacity, illumination condition, battery capacity and battery state of charge. Hence, the output power of some hybrid inverters is short or redundant sometimes, which makes microgrid unstable or causes power generation restraints. It is necessary to recognize the actual power capacity of each inverter and control the output power reasonably. This paper analyzes the characteristics of parallel-connected hybrid inverters with droop control in microgrid. An adaptive power sharing method is developed to identify the unbalanced between the each inverter on DC bus. By adjusting the droop parameters, the output power of each inverter is regulated where the controlled parameters are defined in system transfer function with an optimal target. Experimental tests are executed following the numerical simulation. The results show that the output power of each inverter can be adjusted adaptively according to the practical needs. The excessive power from one inverter can be absorbed by the others. Therefore, the stability and the power capability in the system are both ensured by adopting the proposed methods. The outcomes of the study provide a reference to the development of the adaptive inverter in microgrid.