Abstract
Impedance measurement is an effective method to obtain the impedance model of the renewable power generation equipment (RPGE). On the basis of the measurement points, the impedance characteristic curves of the RPGE can be obtained. The distribution of the measurement points will influence the accuracy of the obtained curves. In order to obtain accurate impedance curves effectively, adaptively adjusted frequency intervals could be used which can reduce the required number of the measurement frequencies and improve the measurement efficiency. Moreover, the existing work can still be further enhanced by implementing fitting algorithm while adaptively adjusting the measurement frequencies. In this paper, an improved adaptive adjustment method for the measurement frequencies in the impedance measurement based on vector fitting algorithm is proposed. By implementing fitting algorithm, the impedance characteristic at unmeasured frequencies can be predicted, which can further raise the measurement efficiency and meanwhile obtain the accurate impedance curves. The measurement frequencies will be adjusted adaptively according to the measurement points and fitting curves. The experiments based on Control-hardware-in-loop (CHIL) are conducted to verify the effectiveness of proposed adaptive frequency adjustment method.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
More From: IEEE Journal of Emerging and Selected Topics in Power Electronics
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.