Abstract

This study evaluates the performance of NiO-based oxygen carriers supported on ZrO2, TiO2, SiO2, Al2O3 and NiAl2O4 as conventional reforming catalysts at low temperature (650°C) as well as oxygen transfer materials (OTMs) for chemical looping steam methane reforming. Conventional reforming experiments with pre-reduced OTMs demonstrated satisfactory performance of NiO/Al2O3, NiO/ZrO2 and NiO/NiAl2O4 at 650°C, with less than 8% relative decrease in conversion after 10h time-on-stream. On the other hand, NiO/SiO2 and NiO/TiO2 were found to have low activity (<50% initial CH4 conversion) and deactivated rapidly, eventually dropping to less than 10% CH4 conversion after 2h on stream. The three most promising materials were tested under chemical looping steam methane reforming conditions for twenty consecutive redox cycles in a fixed bed flow unit. NiO/ZrO2 exhibited good activity with initial CH4 conversion higher than 80% and had very good stability. Deactivation was minimal after 20 consecutive redox cycles, corresponding to 20h exposure to CH4/steam. NiO/Al2O3 and NiO/NiAl2O4 demonstrated similar high initial activity, but also high deactivation, leading to methane conversion of 59 and 63% conversion respectively at the end of the test.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.