Abstract
For photovoltaic (PV) inverter applications, the grid code mandates reactive power support to the grid, and the amount of reactive power injection may be limited by the voltage overshoot during the switching transients of a power device. For SiCMOSFET-based PV inverters, this problem is more pronounced since the voltage and current gradient during switching transitions are much higher than a Si-based power converters. During a cloudy day when the inverter has to operate at PV panels open-circuit voltage, it becomes harder to push higher reactive power support to the grid due to the current derating of the SiC-devices at the operating dc bus voltages to keep the device within its safe operating limits with low switching losses at all operating conditions. Slowing down the switching transient could be a remedy but this also increases the converter losses. This paper demonstrates an application of a dynamic gate resistance modulation technique to keep the SiC-device within its safe operating limits while maintaining a low switching loss with minimum voltage and current overshoots. This helps to inject more power to the grid with at higher dc bus voltages without enhancement of the thermal management system. The proposed implementation also works equally well at high junction temperatures (up to T <sub xmlns:mml="http://www.w3.org/1998/Math/MathML" xmlns:xlink="http://www.w3.org/1999/xlink">j</sub> = 150 °C), which further increases the operating range of the PV inverter.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.