Abstract
Diffusion dialysis (DD) equipped with anion exchange membranes (AEMs) is used as an effective tool to recover acidfrom various types of waste acid solutions. The aim of this study was to investigate the possibility of using the DD process to recover sulfuric acid (HsSO4) from the acidic wastewater from an automotive battery plant. A numbers of experimental runs was conducted to optimize the equipment’s operating conditions, particularly variations in feed flow and flow rate ratios . The results showed that H2SO4 permeated well through the AEM, while metal ions were efficiently rejected. The recovery of H2SO4 increased as flow rate decreased. Approximately 84.5% of H2SO4 could be recovered at 9 .38 × 10 -5 m3 h-1 m-2. Pb2+ rejection was 69.5%. In addition, recovery efficiency could be improved by increasing the flow rate ratio. At the highest flow rate ratio, DD could recover up to 90% of H2SO4 while the lowest rejection of Pb2+ (61%) was obtained. Also, the investigation of the effect of variation of flow rate ratio on recovery efficiency revealed that the optimum flow rate ratio should be controlled at around 1 to 1.2.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.