Abstract
Cellulose nanocrystals (CNCs) prepared by H(2)SO(4) hydrolysis have sulfate groups on their surface, which have negative implications for some CNC applications. In this study, two desulfation methods were evaluated, and the properties of desulfated CNCs were compared to those of unsulfated CNCs, prepared by HCl hydrolysis. H(2)SO(4)-hydrolyzed CNCs from softwood sulfite pulp were subjected to either a mild acid hydrolytic desulfation or a solvolytic desulfation in dimethyl sulfoxide via the pyridinium salt. Removal of the sulfate groups was confirmed by conductometric titration and X-ray photoelectron spectroscopy. The effect of the desulfation procedure on the lateral crystallite dimensions was analyzed by X-ray diffraction. The extent of particle aggregation in the samples was assessed by atomic force microscopy and dynamic light scattering. The acid hydrolytic method achieved only partial desulfation and produced gradually decreasing sulfate contents upon successive repetition. The solvolytic method achieved nearly complete desulfation in a single step. The desulfated CNCs showed similar particle aggregation as the HCl-hydrolyzed CNCs, but the extent of aggregation was slightly less.
Published Version
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
