Acid‐modified carbon nanotubes distribution and mechanical enhancement in polystyrene/elastomer blends

Abstract

AbstractThe incorporation of carbon nanotubes (CNTs) is expected as an effective path for tailoring mechanical properties of polymer blends. In this study, acid‐modified multiwalled CNTs (A‐MWCNTs) were introduced into polystyrene/maleic anhydride‐g‐(styrene‐ethylene‐butadiene‐styrene) (PS/SEBS‐MA) blends. By altering the mass ratio of PS/SEBS‐MA from 80/20 to 60/40, the biphase structure of blend was changed from sea‐island‐like type to quasi co‐continuous structure, of different mechanical behaviors. In 80/20 mass ratio, the impact strength was improved while the tensile strength was unchanged with increasing A‐MWCNTs content, whereas a simultaneously toughening and strengthening effect was achieved for the compound with 60/40 mass ratio. Scanning electron microscopy, polarized light microscopy, dynamic mechanical analysis, and rheological measurements were carried out to detect the distribution of A‐MWCNTs in the blends. The results demonstrated as increasing the nanotube loading from 0 to 3 wt%, A‐MWCNTs might gradually migrate into continuous PS phase in 80/20 mass ratio, due to the low content of SEBS‐MA, while they were totally packed in SEBS‐MA region within the entire loading range used in 60/40 mass ratio due to its high content of SEBS‐MA. This study provides guidance on the design and preparation of high performance ternary polymer/elastomer/inorganic filler composites. POLYM. ENG. SCI., 2012. © 2011 Society of Plastics Engineers