Abstract
The influence of different types of iron salts (i.e., ferrous or ferric cations with sulphate, nitrate or chloride anions) on the reaction between coarse thermomechanical pulp and acid hydrogen peroxide (Fenton chemistry) was studied when the initial pH was 3.2 and 5.3. Also, ferric ions chelated with EDTA or EDG at different molar ratios were compared with ferrous sulphate when the initial pH was extended from about 3 to 8. Different anions of ferric ion salt gave a similar catalytic effect. At an initial pH of 7–8, the ferric-EDTA catalyzed reaction resulted in similar or higher hydrogen peroxide consumption and more detectable hydroxyl radicals than the ferrous sulphate catalyzed reaction, but less reaction with the pulp was indicated. Between pH 5–8, using Fe-EDG as a catalyst gave higher hydrogen peroxide consumption and more detectable hydroxyl radicals than if using ferrous sulphate; however, the measured effect on the pulp was similar or less.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
