Abstract

It is always a great challenge to manufacture defect-free and high-performance pure tungsten by laser additive manufacturing until now. In this work, using nanopowder as precursors, the pure tungsten green parts were successfully manufactured by indirect additive manufacturing technology, powder extrusion printing. The subsequent debinding-sintering process of the green parts has been optimized to obtain high-relative-density, fine-grain and defect-free tungsten samples. The relative density of the sample increased with the increase of sintering temperature. The microstructures of pure tungsten prepared by direct and indirect additive manufacturing techniques were studied comparatively, including laser powder bed fusion and powder extrusion printing. The formation of microcracks in pure tungsten samples is mainly due to the high residual stress provided by laser powder bed fusion and the high ductile-to-brittle transition temperature characteristics of tungsten. The sintering temperature of the pure tungsten samples with the highest compressive strength (1290 ± 10 MPa) was determined to be 2000 °C. Compared with other sintered samples, defect-free samples sintered at 2000 °C had finer grains (9.8 μm) while maintaining high relative density (99.1 ± 0.4%). The higher strength of the sintered samples at 2000 °C is related to the fine-grain strengthening and high relative density compared to samples obtained from other direct additive manufacturing technologies and sintered at other temperatures. The indirect additive manufacturing technique based on the use of nanopowder precursors developed in this work provides a new technical approach for the additive manufacturing of high-performance tungsten and/or other refractory metals.

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.