Achieving enhanced cryogenic toughness in a 1 GPa grade HSLA steel through reverse transformation of martensite

Abstract

The effect of microstructure on crack resistance and cryogenic toughening in a 3.5 wt% Ni high-strength low-alloy (HSLA) steel was investigated. Multistage heat treatments involving quenching (Q), lamellarization (L), and tempering (T) were applied to prepare the HSLA steels with various microstructures, focusing on the reverse transformation and reconfiguration of martensite, as well as its influence on impact crack formation and propagation behavior by multi-scale characterizations. The results indicate that lamellarization treatment has little influence on tensile properties, but significantly improves impact toughness in the QL and QLT specimens, which exhibit over 30 % increment in Charpy V-notch (CVN) absorbed energy Et tested in range from RT to −196 °C, over 25 °C decrement in ductile-brittle transition temperature (DBTT), and much higher crack propagation energy Ep and higher ratio of Ep/Et, as compared with the as-quenched (AQ) and QT specimens. The lamellarization treatment also contributes to a significant refinement effect on martensitic block size, caused by fresh martensite transformation from the reversed austenite, resulting in an increment in high angle grain boundaries (HAGBs), with introduction of a small amount of retained austenite (RA) as well. Therefore, the impact crack resistance and cryogenic toughness is improved in specimens processed with lamellarization treatment, due to the enhancement in crack deflection and hindering effect of the HAGBs, as well as toughening effect by in situ austenite-to-martensite transformation of the RA. Based on the present study, a 1 GPa grade HSLA steel with high ductility and excellent cryogenic toughness can be produced.