Abstract

BackgroundMicrobial malic acid production is currently not able to compete economically with well-established chemical processes using fossil resources. The utilization of inexpensive biomass-based substrates containing acetate could decrease production costs and promote the development of microbial processes. Acetate is a by-product in lignocellulosic hydrolysates and fast pyrolysis products or can be synthesized by acetogens during syngas fermentation. For the fermentation of these substrates, a robust microorganism with a high tolerance for biomass-derived inhibitors is required. Aspergillus oryzae is a suitable candidate due to its high tolerance and broad substrate spectrum. To pave the path towards microbial malic acid production, the potential of acetate as a carbon source for A. oryzae is evaluated in this study.ResultsA broad acetate concentration range was tested both for growth and malic acid production with A. oryzae. Dry biomass concentration was highest for acetic acid concentrations of 40–55 g/L reaching values of about 1.1 g/L within 48 h. Morphological changes were observed depending on the acetate concentration, yielding a pellet-like morphology with low and a filamentous structure with high substrate concentrations. For malic acid production, 45 g/L acetic acid was ideal, resulting in a product concentration of 8.44 ± 0.42 g/L after 192 h. The addition of 5–15 g/L glucose to acetate medium proved beneficial by lowering the time point of maximum productivity and increasing malic acid yield. The side product spectrum of cultures with acetate, glucose, and cultures containing both substrates was compared, showing differences especially in the amount of oxalic, succinic, and citric acid produced. Furthermore, the presence of CaCO3, a pH regulator used for malate production with glucose, was found to be crucial also for malic acid production with acetate.ConclusionsThis study evaluates relevant aspects of malic acid production with A. oryzae using acetate as carbon source and demonstrates that it is a suitable substrate for biomass formation and acid synthesis. The insights provided here will be useful to further microbial malic acid production using renewable substrates.

Highlights

  • Microbial malic acid production is currently not able to compete economically with well-established chemical processes using fossil resources

  • The highest dry biomass titers were obtained with acetic acid concentrations of 40–55 g/L with values ranging between 1.08 ± 0.14 g/L and 1.14 ± 0.11 g/L

  • Considerations regarding the utilization of acetate derived from lignocellulose The results presented in this work show that for an efficient biomass production with A. oryzae, acetic acid concentrations in the range of 40–55 g/L are optimal while regarding the acid production 45–50 g/L are ideal

Read more

Summary

Introduction

Microbial malic acid production is currently not able to compete economically with well-established chemical processes using fossil resources. For the fermentation of these substrates, a robust microorganism with a high tolerance for biomass-derived inhibitors is required. To pave the path towards microbial malic acid production, the potential of acetate as a carbon source for A. oryzae is evaluated in this study. In view of climate change and the depletion of fossil resources, the microbial production of chemicals currently synthesized from crude oil, gas or coal is of great interest. In view of an integrated bioeconomy, malic acid could replace maleic anhydride as building block chemical for the synthesis of various products including succinic anhydride, 1,4-butanediol, tetrahydrofuran and γ-butyrolactone [6, 7]

Methods
Results
Discussion
Conclusion
Full Text
Published version (Free)

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call