Acetabular Diameter Assessment and Three-Dimensional Simulation for Acetabular Reconstruction in Dysplastic Hips

Abstract

BackgroundThis study aimed to investigate the relationship between acetabular width, three-dimensional (3D) simulation, and surgical results in total hip arthroplasty patients who have developmental dysplasia of the hip (DDH). MethodsThis retrospective study included 216 DDH cases. Inner and outer acetabular width (OAW) was measured at the plane passing through the center of acetabular fossa. 3D simulation and 2D standard templating were performed. The actual cup size and the use of augments during surgery were recorded. Association among the indices and their distribution in different types of DDH were analyzed. ResultsA difference of 13 to 14 millimeters (mm) was found between the inner acetabular width and actual cup size used in type II, III, and IV cases, while the difference was 0.2 to 3.6 mm for OAW. The accuracy of 2D templating and 3D simulation in predicting cup size was comparable in Crowe type I (86.5 versus 76%, P = .075), type II (72.7 versus 51.5%, P = .127), and type III (93.3 versus 66.7%, P = .169). The 3D simulation was significantly more accurate in Crowe type IV (89.1% versus 60.9%, P = .001). Augments and bone grafts were significantly more commonly used in type II (25%) than in the other types (0 to 6.5%). ConclusionOAW more accurately predicted actual cup size than inner acetabular width. The supero-lateral acetabular bone defects in type II cases require additional attention. Compared with 2D templating, 3D simulation is more accurate in predicting actual cup size in dysplastic hips with severe deformity and may be recommended in these selected cases, especially for Crowe IV patients.