Abstract
This paper gives an update on current work concerning the development of the method of Dynamic Length Metrology (DLM) to obtain accurate traceable measurements directly in the production. Three case studies are described dealing with diameter measurements with sub-micrometer uncertainty on metallic parts, and dimensional measurements on polymer parts, where the achievable uncertainty of after molding predictions is of a few micrometers.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.