Accuracy Verification of Four-Dimensional CT Analysis of Knee Joint Movements: A Pilot Study Using a Knee Joint Model and Motion-Capture System.

Abstract

Objective This study aimed to use the optical motion-capture method to verify the accuracy of four-dimensional computed tomography (4D-CT) analysis of knee joint movement. Methods One static CT and three 4D-CT examinations of the knee joint model were obtained. The knee joint model was passively moved in the CT gantry during 4D-CT acquisitions. 4D-CT and static CT examinations were matched to perform 3D-3D registration. An optical-motion capture system recorded the position-posture of the knee joint model simultaneously with the 4D-CT acquisitions. Reference axes (X, Y, and Z directions) were defined based on static CT and applied to 4D-CT and the optical-motion capture system. Using the position-posture of the motion capture system as a reference standard, the position-posture measurements using 4D-CT were compared to these values, and the accuracy of the 4D-CT analysis of knee joint movements was quantitatively assessed. Results The position-posture measurements obtained from 4D-CT showed a similar tendency to those obtained from the motion-capture system. In the femorotibial joint, the difference in the spatial orientation between the two measurements was 0.7 mm in the X direction, 0.9 mm in the Y direction, and 2.8 mm in the Z direction. The difference in angle was 1.9° in the varus/valgus direction, 1.1° in the internal/external rotation, and 1.8° in extension/flexion. In the patellofemoral joint, the difference between the two measurements was 0.9 mm in the X direction, 1.3 mm in the Y direction, and 1.2 mm in the Z direction. The difference in angle was 0.9° for varus/valgus, 1.1° for internal/external rotation, and 1.3° for extension/flexion. Conclusions 4D-CT with 3D-3D registration could record the position-posture of knee joint movements with an error of less than 3 mm and less than 2° when compared with the highly accurate optical-motion capture system. Knee joint movement analysis using 4D-CT with 3D-3D registration showed excellent accuracy for in vivo applications.