Accuracy of single-implant digital impression with various scanbody exposure levels at anterior and posterior regions

Abstract

ObjectivesThis in vitro study aimed to evaluate the effect of the exposure heights of the scanbody on the accuracy of digital implant impressions at different positions. MethodsFour maxillary master models with one analog at the anterior and posterior region were fabricated by a 3-dimensional (3D) printer. The analogs were submerged from the gingival margin to ensure four exposure heights of the scanbody: 10, 8, 6, and 4 mm. . The master models were then scanned with D2000 dental laboratory scanner as the reference models. An intraoral scanner obtained ten test models for each group. After aligning the scanbody library file, the related files were imported into inspection software for superimposition by a local fit algorithm based on the adjacent teeth. Results3D trueness was significantly decreased at 6 and 4 mm scanbody exposure at the anterior region. In comparison, a significant decrease was only seen at 4 mm scanbody exposure at the posterior region. 3D precision was significantly decreased at 4 mm scanbody exposure at both anterior and posterior regions. ConclusionThe exposure height of the scanbody influenced the accuracy of the digital implant impression, according to the implant positions. Scanbody exposure of less than 6 mm at the anterior region and 4 mm scanbody exposure at the posterior region could lead to increased deviations, but still in the tolerance range. Clinical significanceThe scanbody exposure height less than 6 mm at the anterior region and 4 mm scanbody exposure height at the posterior region could lead to significantly increased deviations. Though these deviations may be still in the clinically acceptable range, caution should be taken.