Abstract

Abnormal torsion of the femur is correlated to lower extremity pathologies. Although computed tomography (CT) scan is the gold standard torsional measurement, magnetic resonance imaging (MRI) is proposed as a viable alternative. Our aim was to determine the accuracy and consistency of MRI and CT femur rotational studies based on 4 described protocols. Twelve cadaveric femora were stripped of soft tissue before imaging and physical assessment of torsion. Four advanced imaging series were obtained for each specimen: CT with axial cuts of the femoral neck (CT-axial); CT with oblique cuts of the femoral neck (CT-oblique); MRI with axial cuts of the femoral neck (MR-axial); MRI with oblique cuts of the femoral neck (MR-oblique). Anatomic specimens were placed with the posterior femoral condyles flat on a dissection table for assessment of true torsion with digital images. Three independent reviewers performed all measurements, including true torsion, using imaging software. Bland-Altman analysis was repeated with the data from each reviewer. Interobserver repeatability for all groups was high at 0.95, 0.87, 0.90, 0.97, and 0.92 for CT-axial, CT-oblique, MR-axial, MR-oblique, and true torsion, respectively. CT-axial had the lowest mean difference from clinical imaging for all three observers (all <1 degree) and held the tightest 95% limits of agreement for 2/3 observers. As torsion increases from neutral, MR-oblique linearly overestimates the rotation compared with true torsion. CT-oblique and MR-axial showed slightly greater differences from true torsion compared with CT-axial, but did not reach clinical significance. CT-axial was both most accurate and reproducible when compared with true torsion of the femur and should be the gold standard imaging modality; however, both MR-axial and CT-oblique were accurate to a level that is likely less than clinical significance. MR-axial images should be used in clinical situations where radiation exposure needs to be limited. MR-oblique images can overestimate true antetorsion and should not be used. CT-axial followed by MRI-axial is the most accurate and consistent in measuring true torsion of the femur.

Full Text
Paper version not known

Talk to us

Join us for a 30 min session where you can share your feedback and ask us any queries you have

Schedule a call

Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.