Abstract
Acceptance sampling plans for inspection by variables, which minimize the mean inspection cost per lot of process average quality (assuming that the remainder of rejected lots is, inspected), were derived under the condition that the probability of accepting a submitted lot of tolerance quality, shall be 0.1. These plans were tabulated for chosen values of the given parameters, and compared with the Dodge-Romig LTPD attribute sampling plans. From the comparison it follows that under the same protection of consumer the LTPD plans for inspection by variables are in many situations more economical than the corresponding Dodge-Romig plans. This result is valid especially for the large lots and for the small values of the tolerance fraction defective.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
