Abstract
The results of numerical modeling and experimental realization of the impact of a chemically reacting gas flow on powder particles during profiling (diameter increase while maintaining volume) of the barrel combustion chamber of a unit for detonation spraying are given. The passage from the combustion chamber into the barrel muzzle is made using connecting taper sleeves with a small narrowing angle. It is shown that such profiling can significantly reduce the barrel size without compromising the technological capabilities of the detonation unit.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.