Abstract
A sensitive magnetic sensor based on the measurement of reflected incident power from magnetoimpedance (MI) multilayer-film element incorporated into 50 /spl Omega/ matching network has been produced. The film system was fabricated by radio-frequency sputtering having two outer magnetic layers (NiFe), insulation layers (AlO/sub 3/), and inner conductor Au. For optimized layer parameters, an MI ratio of 135%, sensitivity 15%/Oe, and linearity within -2.5 and 5 Oe was obtained at a frequency of 434 MHz. An ac sense magnetic field applied to the MI element results in a small amplitude modulation signal due to the impedance variation, which can be measured on the carrier signal. For the sense field frequency of 1 kHz, the resolution of 3.73/spl times/10/sup -7/ Oe was achieved. To improve the field resolution at lower frequencies (<100 Hz), the use of an ac bias technique has been proposed. For a sense field of 20 and 10 Hz with 5 kHz ac bias, field resolutions of 4.78/spl times/10/sup -6/ Oe and 5.27/spl times/10/sup -6/ Oe, respectively, have been obtained.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.