Absorption spectroscopy characterization measurements of a laser-produced Na atomic beam

Abstract

A pulsed Na atomic beam source developed for spectroscopic diagnosis of a high-power ion diode is described. The goal is to produce a ∼1012-cm−3-density Na atomic beam that can be injected into the diode acceleration gap to measure electric and magnetic fields from the Stark and Zeeman effects through laser-induced fluorescence or absorption spectroscopy. A ∼10 ns full width at half-maximum (FWHM), 1.06 μm, 0.6 J/cm2 laser incident through a glass slide heats a Na-bearing thin film, creating a plasma that generates a sodium vapor plume. A ∼1 μs FWHM dye laser beam tuned to 5890 Å is used for absorption measurement of the Na I resonant doublet by viewing parallel to the film surface. The dye laser light is coupled through a fiber to a spectrograph with a time-integrated charge-coupled-device camera. A two-dimensional mapping of the Na vapor density is obtained through absorption measurements at different spatial locations. Time-of-flight and Doppler broadening of the absorption with ∼0.1 Å spectral resolution indicate that the Na neutral vapor temperature is about 0.5–2 eV. Laser-induced fluorescence from ∼1×1012 cm−3 Na I 3s-3p lines observed with a streaked spectrograph provides a signal level sufficient for ∼±0.06 Å wavelength shift measurements in a mock-up of an ion diode experiment.