Abstract
The Kavaratti calibration-validation site in India at Lakshadweep Sea has been improved to carry out absolute calibration of SARAL/AltiKa altimeter. This site is augmented with a down-looking radar gauge and a permanent GPS receiver. The Kavaratti Island is located near a repeating ground track of SARAL/AltiKa and ∼12 km away from the point of closest measurement of Jason-2, SARAL/AltiKa crossover point. Additionally, the altimeter and radiometer footprints do not experience any land contamination. This article aims at presenting the initial calibration-validation results over cycles 001-011 of AltiKa. The absolute sea surface height bias has been found to be −48 mm at Kavaratti calibration site. In this preliminary study the effect of environmental variables such as winds and pressure are not considered in calculations.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
