Abstract
Wear properties of two different crushers used for grinding raw materials of cement industry are compared using pin-on-disk wear test. The wear test was carried out with different loads on a pin. Abrasive wear behavior of two alloys was evaluated by comparing mass loss, wear resistance, microhardness and friction coefficient. The microstructure of the specimens was detected using optical microscope. The results showed that abrasive wear of high chromium cast iron is lower than that of Hadfield steel. Due to the presence of M7C3 carbides on the high chromium cast iron matrix, impact crushers exhibited higher friction coefficient.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
