Abstract
Hard abrasion-resistant coatings for ophthalmic plastics were obtained from mixtures of tetraethoxysilane, 3-metacryloxypropyltrimethoxysilane and methyl methacrylate, and were cured at 120°C and 140°C for different times. The Tumble test was used to measure the abrasion resistance of these coated plastics. This abrasion resistance was strongly dependent on the curing time and temperature. The infrared analysis of the curing processes showed that, in order to achieve the highest abrasion resistance, these acrylic hybrid coatings must be fully polymerized, but overcuring must be carefully avoided. Finally, a linear correlation was found between the abrasion resistance of these coated samples (as measured by the Tumble test) and their microhardness.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.