Abstract
AbstractThe ablative properties of epoxy modified silicone rubber composites filled with zinc borate (ZB) and aluminum hypophosphite (AHP) were studied. The decomposition of the added fillers and covering connection of residual on the substrate contribute to the improvement of heat insulation. The ablation test shows that the formation of a dense char layer with certain strength is key to improving the ablative properties. The optimal ablative performance is achieved when the concentration of ZB and AHP is 10 and 5 phr, respectively. Under such circumstances, the linear ablation rate is as low as 0.032 mm/s, which is about 61% lower than the pure silicone rubber. Furthermore, the structure and composition of the formed char layer were analyzed using X‐ray diffraction analysis, scanning electron microscopy, and Fourier transform infrared spectroscopy.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have