A Two-dimensional Stress Analysis and Strength of Single-lap Adhesive Joints of Dissimilar Adherends Subjected to External Bending Moments

Abstract

The stress distributions of single-lap adhesive joints of dissimilar adherends subjected to external bending moments are analyzed as a three-body contact problem by using a two-dimensional theory of elasticity (plane strain). In the analysis, dissimilar adherends and an adhesive are replaced by finite strips. In the numerical calculations, the effects of the ratio of Young's moduli of adherends, the adherend thickness ratio and the adherend length ratio between dissimilar adherends on the stress distributions at the interfaces are examined. The results show that the stress singularity occurs at the ends of the interfaces, and its intensity is greater at the interface of the adherend with smaller Young's modulus. It is also noted that the singular stress is greater at the interface of the thinner adherend. It is found that the effect of the adherend length ratio on the stress singularity at the interfaces is very small. Joint strength is predicted by using the interface stress and it was measured by experiments. From the analysis and the experiments, it is found that the joint strength increases as Young's modulus of adherends and the adherend thickness increase while the effect of the adherend lengths on the joint strength is small. For verification of the analysis, a finite element analysis (FEA) is carried out. A fairly good agreement of the interface stress distribution is seen between the analytical and the FEA results.