Abstract
In this paper, an integrated design with a multiple-input multiple-output (MIMO) antenna system for fourth generation (4G) and fifth generation (5G) applications is presented. The proposed design contains a two-element slot-based MIMO antenna system for 4G and a connected antenna array (CAA)-based two-element MIMO antenna system for a potential 5G band. Two rectangular loops are etched on the periphery of the ground plane. The top and bottom portions of the thin loops act as the two 4G MIMO antennas, while parts of their sides are acting as 5G arrays. The antenna system is fabricated on a commercially available Roger 4350 substrate with $\epsilon _{r}$ equal to 3.5, while the dimensions of the board are $100\times 60 \times 0.76$ mm3 representing a typical smart phone back plane size. The integrated antenna system covers multibands at 4G with a combined bandwidth of 1.565 GHz (−6 dB BW) in addition to the band between 16.50 and 17.80 GHz for 5G. The design is planar, low profile, simple, and compact in structure making suitable for wireless handheld devices and mobile terminals. The measured gain at 3.46 GHz was at least 2.22 dBi and at 17 GHz was 8 dBi for the 4G and 5G MIMO antenna systems, respectively. The envelope correlation coefficient was also calculated from the measured 3-D patterns and showed good MIMO performance. This is the first integrated 4G/5G MIMO antenna system with below 6 GHz and above 10-GHz covered bands using CAA.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.