Abstract
This paper describes a new three-axis tactile sensor equipped with an optical waveguide plate mounted on a robot manipulator. After a series of FEM contact analyses and evaluation experiments were conducted, an experimental large-sized tactile sensor intended for employment in evaluation experiments was designed and produced. The experimental results confirmed that the tactile sensor is capable of detecting the distribution of three-axis force and that the calculated and experimental results coincide well. On the basis of these results, a smaller tactile sensor mounted on a robot manipulator was designed and produced. This tactile sensor comprises a CCD camera, a light source, an acrylic board and a silicon rubber sheet that are assembled into a casing 180 mm long, 80 mm wide and 50 mm thick.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.