Abstract
Advanced integrated-gasification combinedcycle (IGCC) and integrated-gasification fuel cell (IFGC) systems require high-temperature sorbents that are capable of removing hydrogen chloride and hydrogen sulfide from coal derived gases to very low levels. HCl and H2S are highly reactive, corrosive, and toxic gases that must be removed to meet stringent environmental regulations, to protect power generation equipment and to control the emissions of contaminants. The thermodynamic behavior of 13 sorbents for the removal of HCl and H2S under various conditions including: initial toxic gas concentration (1–10000 ppm), operating pressure (0.1–11 Mpa), temperature (300 K–1500 K), and the presence of H2O were investigated. The correlation between HCl and H2S was also examined. Thermodynamic calculations were carried out for the reactions of the 13 sorbents using a FactSage 5.2 software package based on free energy minimization. The sorbents, Na2CO3, NaHCO3, K2CO3, and CaO are capable of completely removing chlorine at high temperatures (up to ∼1240 K) and at high pressures. Water vapor did not have any significant effects on the dechlorination capability of the sorbents. Nine of the sorbents namely; Cu2O, Na2CO3, NaHCO3, K2CO3, CaO, ZnO, MnO, FeO, and PbO, were determined to have great potential as desulfurization sorbents. Cu2O and ZnO had the best performance in terms of the optimum operating temperature. The addition of water vapor to the reactant gas produces a slightly detrimental effect on most of the sorbents, but FeO exhibited the worst performance with a reduction in the maximum operating temperature of about 428 K. The dechlorination performance of the alkali sorbents was not affected by the presence of H2S in the reactions. However, the desulfurization capability of some sorbents was greatly affected by the presence of HCl. Particularly, the performance of Cu2O was significantly reduced when HCl was present, but the performance of FeO improved remarkably. The thermodynamic results gathered are valuable for the developments of better sorbents.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.