Abstract
Grafting-through atom transfer radical polymerization (ATRP) was used to polymerize a sterically hindered poly(dimethylsiloxane) methacrylate (PDMS11MA, Mn = 1000) macromonomer to high conversion as a function of temperature, solvent, initial monomer concentration, and pressure. Higher polymerization yields were obtained when polymerizations were conducted at (i) lower temperature (T), (ii) in a poor solvent for the side chain, (iii) higher initial monomer concentration ([M]0), and (iv) higher pressure by mitigating the contribution of the equilibrium monomer concentration ([M]eq). The enthalpy of polymerization (ΔHp) and entropy of polymerization (ΔSp) were more negative in poor solvents. Polymerizations at ambient pressure required higher [M]0, use of a poor solvent, and lower temperatures to reach higher conversion with good control, whereas high pressure ATRP (HP-ATRP) displayed better control under dilute conditions. Grafting-through polymerization at high P and higher [M]0 was less controlled, plausibly due to limited solubility and mobility of the copper catalyst in the highly viscous medium.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
