Abstract
Averaging network is adopted to reduce the front-end amplifier's offset in the flash analog-to-digital converter (ADC) commonly at the cost of the boundary threshold error. Such error worsens the integral-nonlinearity and introduces distortion. An averaging termination scheme using intended asymmetric spatial filter response is proposed to overcome this problem. It matches the impulse response window width, W IR, to the active zero-crossing response window width, W ZX at the boundary of network. Analysis and simulation show that by tuning the ratio between termination resistor R T and averaging resistor R 1, the boundary error is reduced as close as to 1%. This method provides sufficient reliability since the resistance matching can be fabricated as high as 1% in modern CMOS technology. Its feasibility for the flash ADC has been validated by a 1GS/s 4-bit flash converter.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
