Abstract
A charge pump that utilizes a MOSFET body diode as a charge transfer switch is discussed. The body diode is characterized and a body diode model is developed for simulating the charge pump circuit. A 10% increase of voltage gain has been achieved in the proposed switching technique when compared with a traditional Dickson charge pump. The top plate and bottom plate switching technique have also been illustrated to improve the efficiency of the charge pump. A six-stage Dickson charge pump was designed to produce a 19 V output from a 3.3-V supply, using a 4 MHz, two-phase nonoverlapping clock signal driving the charge pump. The design was fabricated in a 0.35-/spl mu/m SOI CMOS process. An efficiency of 79% is achieved at a load current of approximately 19 /spl mu/A.
Sign-in/Register to access full text options 
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: IEEE Transactions on Circuits and Systems II: Express Briefs
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
