A study on weld line morphology and mechanical strength of injection molded polystyrene/poly(methyl methacrylate) blends

Abstract

AbstractIn this work, the mechanical strength and weld line morphology of injection molded polystyrene/poly(methyl methacrylate) (PS/PMMA) blends were investigated by scanning electron microscopy (SEM) and mechanical property test. The experimental results show that the tensile strength of PS/PMMA blends get greatly decreased due to the presence of the weld line. Although the tensile strength without the weld line of PS/PMMA (70/30) is much higher than that of the PS/PMMA (30/70) blend, their tensile strength with weld line shows reversed change. The viscosity ratio of dispersed phase over matrix is a very important parameter for control of weld‐line morphology of the immiscible polymer blend. In PS/PMMA (70/30) blend, the PMMA dispersed domains at the core of the weld line are spherically shaped, which is the same as bulk. While in the PS/PMMA (30/70) blend, the viscosity of the dispersed PS phase is lower than that of the PMMA matrix, the PS phase is absent at the weld line, and PS particles are highly oriented parallel to the weld line, which is a stress concentrator. This is why weld line strength of PS/PMMA (30/70) is lower than that of PS/PMMA (70/30) blend. © 2002 Wiley Periodicals, Inc. J Appl Polym Sci 84: 1856–1865, 2002; DOI 10.1002/app.10450