Abstract
This paper describes an experimental research to find the effect of the degree of tool finishing on the roughness of machined surface. By orthogonal cutting of mild steel we observed the relation between the roughness of cutting edge of tools finished with several kinds of method and the roughness of machined surfaces. This experiment reveals that the surface roughness is not affected by the roughness of cutting edge, if it is less than a certain limit, and that the increase of surface roughness eith roughness of cutting edge is attributed to the growth of built-up edge.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callMore From: Transactions of the Japan Society of Mechanical Engineers
Disclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
