Abstract
Abstract: The current investigation is a preliminary approach proposing the feasibility of a modified joint configuration namely double-butt-lap (DBL) in the field of friction stir welding (FSW). The main scope of adopting this kind of joint configuration is to essentially eliminate the irregularities in material flow and defects (root gap, kissing bond) that are observed while joining by using the commonly followed simple square butt joint configuration (SSB) technique. Two different geometries of the joint configuration are fabricated on 6 mm thick AA6061-T6 plates. FSW is carried out at a parametric combination of 1100 rpm, 75 mm/min and 1.5° tilt angle. The comparison of the macrographs of DBL with SSB reveals a quite distinct cross-sectional macrostructure of DBL from SSB in terms of material flow in the nugget zone (NZ). Sharp material flow lines without any macro defects are observed in the case of DBL 2. Mechanical test analysis reveals remarkable enhancement in the mechanical properties of some joint configuration of DBL over SSB. The current research work may act as a foundation for future research work in the utility of such configurations in the diverse field of FSW.
Talk to us
Join us for a 30 min session where you can share your feedback and ask us any queries you have
Schedule a callDisclaimer: All third-party content on this website/platform is and will remain the property of their respective owners and is provided on "as is" basis without any warranties, express or implied. Use of third-party content does not indicate any affiliation, sponsorship with or endorsement by them. Any references to third-party content is to identify the corresponding services and shall be considered fair use under The CopyrightLaw.
